Products
.jpg)
- High Stability
- Self-testing feature for Self-Recovery In case of the system failure, iTDC tests itself to find the problem and recovers the system. iTDC system does not fail in any environment.
- Protection from ESD Power and ground have been separated to protect the device from ESD.
- Integration with Other Security Systems
iTDC can be integrated with other security systems such as CCTV, fire alarm, BAS and other systems to configure total security system. - 30 Input/Output Ports to Control up to Four Doors
Seven input ports, seven output ports and four readers are embedded to connect with variety of sensors, alarms and other devices. In case of adding EIO88 extension board, the total numbers of input and output ports increase to eight each, which makes it total of 30 input and output ports. (EIO88 Optional) - Connect up to 255 iTDCs Together
Using the network communication, 255 iTDCs can be connected together to configure medium or large size system.
- Optimized Communication Function
Depending on the network status, the communication spend is alternated to maintain reliable communication feature. - Variety of Communication Function
Using either serial or TCP/IP communication, it provides reliable network system. Also using the multi-port feature, network and serial communication can be used together. (Internal TCP/IP Module Optional)
- Door Opening Time Configurable per User
The door opening time is configurable by users, which is suitable for disabled or aged users. - Monitoring of Door Opening and Closing
Using the management software, it allows real-time monitoring and control of door opening and closing of the whole system.
- Simple Access Control System Configuration
For the areas where the system configuration difficult, standalone access control system can be configured just by connecting keypad and LCD panel to the controller.
This function is used to manage the visitors. The visitors are only accessible when accompanied by authorized administrator. The doors are opened when two registered cards are read together.
This function is used to prevent any entry or exit of unauthorized users by allowing exit only when proper identification is authorized.
This function is used to notify a dangerous situation or in case of the situations where the users are forced by thieves or criminals to open the door. Using the duress mode, the user can enter the two digit pre-configured duress mode code and the door will open as usual, but it generates the duress alarm output, which activates alarm event to be notified by e-mail or SMS messaging.
This function is used to increase the security level by denying the access if the administrator is not present. If the system is armed by the administrator, none of the access is granted, unless the system is unarmed by the administrator.
This function self detects whether the devices connected to the controller are sending normal signal, if not it can be confirmed using the software.
Panel (EIO88 required to Control 3 and 4 Doors)
Buffers
: 1,000 ~ 20,000 / 30,000 / 40,000 / 50,000 Users
20,000 ~ 29,500 / 3,000 / 8,000 / 14,000 Event Buffers
(Max.255ch), Ethernet (Internal Ethernet Module required /optional)
Outputs
34bit Wiegand and 4 / 8bit Burst for PIN
Standalone Operation, Manual Setting
(by Application Software)
Internal Ethernet Module, Expansion I/O Board
FACEO06SR
